Options

This software not only draws 3D graphics of a minuscule workpiece surface measured by the NEXIV system, but it also provides various analyses such as the calculation of various evaluation values.

This software provides evaluations on various parameters of the measured workpiece, including pitch deviations, tooth space runout, base tangent length, and dimension overpin, based on industrial standards.

Using a DDE Link function, measured data can be immediately transferred to spreadsheets such as Microsoft Excel®, SPC-PC IV, SPC-PC IV Excel, and others, making real-time SPC analysis possible.

Note: SPC-PC IV and SPC-PC IV Excel are products of Quality America Inc.

This program creates teaching data using CAD design data. With excellent data compatibility and coordination capabilities between different data, this program promotes streamlined inspection.

• Supports commands necessary to measure lead frames, lead width, lead angle, and so on.
• Eliminates manual input work, allowing automatic measurements to be started immediately after components are delivered.
• Because CAD data can be checked during the preparation of teaching data, trouble in measuring product dimensions can be detected beforehand.

Notes: This software is a product of Pronics Co., Ltd. To use Measuring CAD^NF Super, AutoCAD R14 is required.

The RI-3600L can rotate the image of a workpiece and display it with a 0.01° resolution. Because it can be controlled externally, it enables automatic measurements while controlling the posture of the workpiece.

Minimum readout: 1”
Control resolution: 0.01°
Max. workpiece diameter: 75mm
Operation mode: Auto or Manual
Pre-set points: Point of origin and 3 others

This pneumatic-type isolation table effectively absorbs external vibrations preventing them from affecting measurements.

This light is handy for checking equipment conditions from the location apart from the equipment.